Disassembly and Assembly

CAUTION: Sub fuel level sensor unit cannot be disassembled and should be replaced as a unit.

DISASSEMBLY
Remove fuel level sensor unit with the following procedure.




1. Disconnect harness connector.
- Hold connector by fingers and pull it out, because there is no stopper release tab.




2. Using a suitable tool, pull up tabs as shown in the figure (2 points) to release the lock.

CAUTION: Be careful not to damage it.




3. Slide fuel level sensor unit out in direction shown by the arrow.

CAUTION: Do not disassemble fuel filter and fuel pump assembly.

ASSEMBLY
Install in the reverse order of removal paying attention to the following.
1. Check for damage at installation position of the fuel filter and fuel pump assembly side fuel level sensor unit.
2. Slide fuel level sensor unit until it aligns to installation groove, then insert it until stop.
- After inserting, apply force in reverse direction (removal direction) to ensure it cannot be pulled out.
3. Securely insert harness connector until it stops.