Inspection Procedure

CONSULT-II Function

CONSULT-II INSPECTION PROCEDURE

CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carry out CAN communication.

1. Turn ignition switch OFF.




2. Connect "CONSULT-II" and "CONSULT-II CONVERTER" to data link connector, which is located under LH dash panel near the hood opener handle.
3. Turn ignition switch ON.




4. Touch "START (NISSAN BASED VHCL)".




5. Touch "ICC" on the selection screen.
If "ICC" is not indicated, go to "CONSULT-II Data Link Connector (DLC) Circuit". CONSULT-II Checking System




6. Touch any of "WORK SUPPORT", "SELF-DIAG RESULTS", "DATA MONITOR", "ACTIVE TEST" and "ECU PART NUMBER" on selection screen.

WORK SUPPORT

Work Item:

Work Item

Cause of Auto-Cancel




1. Touch "WORK SUPPORT" on the selection screen, refer to "CONSULT-II INSPECTION PROCEDURE".
2. Touch "CAUSE OF AUTO-CANCEL" on the selection screen.
3. Cause of automatic cancellation screen will be shown.

CAUTION: Last five cancel (system cancel) causes are displayed.

Display Item List:

Display Item List

Laser Beam Adjust
For details, refer to "LASER BEAM AIMING ADJUSTMENT".

SELF-DIAGNOSTIC RESULTS
For details, refer to "Diagnostic Trouble Code (DTC) Chart".

DATA MONITOR

Operation Procedure




1. Touch "DATA MONITOR" on the selection screen "CONSULT-II INSPECTION PROCEDURE".
2. Touch any of "ECU INPUT SIGNALS", "MAIN SIGNALS", "CAN DIAG SUPPORT MNTR", and "SELECTION FROM MENU" on selection screen.
3. Touch "SETTING".
4. Display the data monitor.
5. If necessary, touch "COPY" in turn, and print data.

Monitored Item Part 1:

Monitored Item Part 2:

Monitored Item Part 3:

Monitored Item

ACTIVE TEST

Caution
- Do not perform the active test while driving.
- Active test cannot be started while ICC system warning indicator illuminates.

1. Touch "ACTIVE TEST" on selection screen "CONSULT-II INSPECTION PROCEDURE".




2. Touch any of "ICC BUZZER 1", "METER LAMP", "STOP LAMP" and "BOOSTER SOL/V 3" on selection screen.
3. Touch necessary item and "START".
4. Active test screen will be shown.

ICC BUZZER 1







- Touch "ON" and "OFF" to check that ICC warning chime operates as in the following chart.

METER LAMP







- Start engine.
- Touch "ON" and "OFF" to check that ICC system display operates as in the following chart.

STOP LAMP







- Touch "ON" and "OFF" to check that stop lamp operates as in the following chart.

BOOSTER SOL/V 3







- Touch any of "MODE 1", "MODE 2", "MODE 3" to check that following operation condition is caused by operating monitor and brake pedal.
- "START" is displayed 10 seconds after operation start. (Active test is completed.)