Unified Meter and A/C Amp
CONSULT-II Function:
CONSULT-II Function
CONSULT-II BASIC OPERATION
CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carry out CAN communication.
1. With the ignition switch OFF, connect "CONSULT-II" and "CONSULT-II CONVERTER" to the data link connector, then turn ignition switch ON.
2. Touch "START (NISSAN BASED VHCL)".
3. Touch "METER A/C AMP" on "SELECT SYSTEM" screen. If "METER A/C AMP" is not indicated, go to Information Bus, "Precautions When Using CONSULT-II".
4. Select "SELF-DIAG RESULTS" or "DATA MONITOR".
SELF-DIAGNOSTIC RESULTS
Operation Procedure
1. Touch "SELF-DIAG RESULTS" on "SELECT DIAG MODE" screen.
2. Self-diagnosis results are displayed.
Display Item List:
Display Item List
"TIME" indicates the condition of the self-diagnosis results judged by each signal input.
- Normal: In case of operating properly at the present in spite of having malfunction in the past, then "TIME" indicates "1-63".
- Malfunction: Soon after detecting malfunctions by self-diagnoses or current malfunction, "0" is indicated.
After returning to normal condition, every time when ignition switch is turned to "OFF" from "ON", time will be added like "1"-> "2"-> "3"--- "63", and when the key operation is performed 64 times, the result of the self-diagnoses will be erased. And if any malfunction is detected again, "0" will be indicated.
CAUTION: "TIME" keeps showing "0" after returning to normal condition only in the case that malfunction history of "CAN COMM CIRC [U1000]" remains because of low tire pressure warning control unit, display control unit (with NAVI) or display unit (without NAVI) malfunction.
DATA MONITOR
Operation Procedure
1. Touch "DATA MONITOR" on "SELECT DIAG MODE" screen.
2. Touch either "MAIN SIGNALS", "CAN DIAG SUPPORT MNTR" or "SELECTION FROM MENU" on the "DATA MONITOR" screen.
3. When "SELECTION FROM MENU" is selected, touch individual items to be monitored. When "MAIN SIGNALS" is selected, main items will be monitored.
4. Touch "START".
5. Touch "RECORD" while monitoring, then the status of the monitored item can be recorded. To stop recording, touch "STOP".
Display Item List Part 1:
Display Item List Part 2:
Display Item List Part 3:
Display Item List
NOTE: Any monitored item that does not match the vehicle being diagnosed is deleted from the display automatically.
*1: Monitor keeps indicating "OFF" when brake warning lamp is on by the parking brake operation or low brake fluid level.
*2: CAN status indicates the condition of the CAN communication judged by each signal input.
- Normal: If any problems were not found in the past, CAN status indicates "0". In case of operating properly at the present in spite of having problem in the past, then CAN status indicates "39-1".
- Malfunction: If there is a malfunction, CAN indicates "40".
After returning to normal condition, every time ignition switch is turned OFF from ON, the indication will change like "39"-> "38"-> "37"--- "1". And if a malfunction is detected again, CAN status indicates "40". (Though returning to the normal condition, "0" is not indicated. To reset, select and press the "ERASE" on the "SELF-DIAGNOSIS" screen.)