Diagnostic Procedure 5

DIAGNOSTIC PROCEDURE 5
Inspecting SRS intermittent malfunction by using CONSULT-II - Diagnosis mode

CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carry out CAN communication.

1. Turn ignition switch OFF.




2. Connect CONSULT-II and CONSULT-II CONVERTER to data link connector.
3. Turn ignition switch ON.




4. Touch "START (NISSAN BASED VHCL)".




5. Touch "AIR BAG".
If "AIR BAG" is not indicated, Refer to "CONSULT-II Data Link Connector (DLC) Circuit". CONSULT-II Checking System




6. Touch "SELF-DIAG [PAST]".







7. If diagnostic codes are displayed on "SELF-DIAG [PAST]", go to Step 10.
If no malfunction is detected on "SELF-DIAG [PAST]", touch "BACK" and go back to "SELECT DIAG MODE".




8. Touch "TROUBLE DIAG RECORD".

NOTE: With "TROUBLE DIAG RECORD", diagnosis results previously erased by a reset operation can be displayed.




9. Diagnostic code is displayed on "TROUBLE DIAG RECORD".
10. Touch "PRINT".
11. Compare diagnostic codes to "DIAGNOSTIC PROCEDURE 5".
12. Touch "BACK" key of CONSULT-II until "SELECT SYSTEM" appears.
13. Turn ignition switch OFF, then turn off and disconnect CONSULT-II, and both battery cables.
14. Repair the system as outlined by the "Repair order" in "Intermittent Malfunction Diagnostic Code Chart", that corresponds to the self-diagnostic result. For replacement procedure of component parts, refer to the Removal and Installation procedure for the appropriate component.
15. Go to "DIAGNOSTIC PROCEDURE 3" , for final inspection.

CONSULT-II Diagnostic Code Chart ( "SELF-DIAG (PAST)" Or "TROUBLE DIAG RECORD") Part 1:

CONSULT-II Diagnostic Code Chart ( "SELF-DIAG (PAST)" Or "TROUBLE DIAG RECORD") Part 2:

CONSULT-II Diagnostic Code Chart ( "SELF-DIAG (PAST)" Or "TROUBLE DIAG RECORD") Part 3:

CONSULT-II Diagnostic Code Chart ("SELF-DIAG [PAST]" or "TROUBLE DIAG RECORD")