Crash Zone Sensor

Removal and Installation

REMOVAL

CAUTION: Before servicing SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes.

1. Remove front grille.




2. Remove crash zone sensor connector.
3. Remove crash zone sensor fixing nuts.

CAUTION:
- Replace crash zone sensor if it has been dropped or sustained an impact.
- Do not disassemble crash zone sensor.

INSTALLATION
Install in the reverse order of removal.

CAUTION:
- Check crash zone sensor for proper installation.
- After the work is complete, perform self-diagnosis to make sure that no malfunction is detected.