Service Procedure C

SERVICE PROCEDURE C: Steering Lock Unit ID Registration

Before starting this procedure, note the following:

^ This procedure is required only after replacing the Intelligent Key Control Unit and/or replacing the Steering Lock Unit with a used unit. A used unit is one that has been installed in a vehicle and operated.

^ You must have at least one registered emergency or valet mechanical key and one registered Intelligent Key to complete the Steering Lock Unit ID Registration.

^ Use the NATS (purple) Program Card version AENO2C or later.

^ It is highly recommended that you read through the entire service procedure before doing it for the first time.

1. Insert the NATS (purple) Program Card into slot A of the CONSULT-II.

2. Connect CONSULT-II and CONSULT-II CAN converter and cable set to the vehicle's data link connector.

3. Turn the CONSULT-II unit ON using the power switch on the front of the unit.

4. Wait for the CONSULT-II system software to load then select: [START] > [OTHER] > [OK].

5. The CONSULT-II screen will indicate "Cannot Detect IGN Signal". You'll need to select [Continue] at the bottom of the screen.

NOTE:
CONSULT-II can communicate with the vehicle even when the ignition switch is OFF.

6. On the SELECT SYSTEM screen select: [NATS I-KEY] > [WORK SUPPORT] > [REGIST STRG LOCK ID] > [START] > [REGIS]





7. Slowly push in on the Ignition "Knob". See Figure 7.

8. When REGISTRATION COMPLETED is displayed on the CONSULT-II screen this Steering Lock Unit ID Registration process is completed.

9. Select END to exit the registration function.

10. Select BACK to return to the SELECT SYSTEM screen.

11. Turn the CONSULT-II unit OFF and disconnect it from the vehicle.