Front Door Panel: Service and Repair

DOOR FINISHER




Removal and Installation

DOOR FINISHER (FRONT AND REAR)

Removal
1. Remove door finisher cap of inside handle portion and remove bolt.
2. Remove door grip cap and remove bolts of door grip portion.




3. Insert screw driver rolled with cloth between panel on vehicle and clips (as indicated with arrow), and remove finisher.
4. Pull up door finisher, and remove electrical parts connectors.




5. Remove lock knob cable, inside handle cable and illumination harness connector (front door only) from backside of inside handle assembly.
6. Remove inside handle screws, and remove it from finisher.

Installation
Install in the reverse order of removal.

CAUTION: To install finisher, check if all clips are matched over holes of panel on vehicle, then push it.