Rear Door Lock

REAR DOOR LOCK




Removal and Installation

REMOVAL
1. Remove the rear door finisher.




2. Disconnect the inside handle knob cable and lock knob cable from the back side of the front door finisher.
3. Remove the rear door sealing, glass and corner piece assembly.




4. Remove door side grommet, and remove outside handle escutcheon bolt (TORX T30) from grommet hole.

CAUTION: Do not forcibly remove the TORX bolt (T30).




5. While pulling the outside handle, remove outside handle escutcheon.




6. While pulling outside handle, slide toward rear of vehicle to remove outside handle.




7. Remove the front gasket and rear gasket.




8. Remove the TORX bolt (T30), and remove the outside handle bracket.




9. While pulling outside handle, slide toward front of vehicle to remove outside handle bracket.




10. Reach to separate outside handle cable connection.




11. Remove the TORX bolts (T30) of door lock assembly.
12. Disconnect the door lock actuator connector and remove door lock assembly.

INSTALLATION
Install in the reverse order of removal.

CAUTION: To install each rod, be sure to rotate the rod holder until a click is felt.