With Manufacturer's Scan Tool (CONSULT-II)

CONSULT-II Function (BCM)

CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carry out CAN communication.

1. Turn ignition switch ON.




2. Connect "CONSULT-II and CONSULT-II CONVERTER" to the data link connector.




3. Turn ignition switch ON.
4. Touch "START (NISSAN BASED VHCL)".




5. Touch "BCM".
If "BCM" is not indicated, go to GI-40, "CONSULT-II Data Link Connector (DLC) Circuit". Data Link Connector Schematic




6. Touch "RETAINED PWR".




7. Select diagnosis mode. "ACTIVE TEST", "WORK SUPPORT" and "DATA MONITOR" are available.