Without Transmitter Activation Tool

ID REGISTRATION WITHOUT ACTIVATION TOOL
This procedure must be done after replacement of a transmitter or BCM.

CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunction might be detected during self-diagnosis depending on control unit which performs CAN communication.

1. With the ignition switch OFF, connect CONSULT-II and CONSULT-II CONVERTER to the data link connector, then turn the ignition switch ON.
2. Select START (NISSAN BASED VHCL).
3. Select BCM on SELECT SYSTEM screen.

NOTE: If BCM is not indicated, go to GI-40, CONSULT-II Data Link Connector (DLC) Circuit. Data Link Connector Schematic

4. Select AIR PRESSURE MONITOR on SELECT WORK ITEM screen.
5. Select WORK SUPPORT on SELECT DIAG MODE screen, and select ID REGIST.





6. Adjust the tire pressure to the values shown in the table for ID registration, and drive the vehicle at 40 km/h (25 MPH) or more for a few minutes.





7. After completing all ID registrations, press END to complete the procedure.
8. Inflate all tires to proper pressure.