Evaporator Temperature Sensor / Switch: Service and Repair

INTAKE SENSOR

Removal and Installation

REMOVAL
1. Remove low-pressure pipe 2 and high-pressure pipe 3. Refer to "Removal and Installation of Low-Pressure Pipe 2 and High-Pressure Pipe 3".

CAUTION: Cap or wrap the joint of the pipe with suitable material such as vinyl tape to avoid the entry of air.




2. Slide the evaporator to passenger side, and then remove the intake sensor.

INSTALLATION
Installation is basically the reverse order of removal.

CAUTION:
- Replace O-rings for A/C piping with new ones. Before installing, apply compressor oil to them
- Connection point for female-side piping is thin. So, when inserting male-side piping, take care to deform female-side piping. Slowly insert in axial direction.
- Insert one-touch joint connection point securely until it clicks.
- After piping has been connected, pull male-side piping by hand to make sure piping does come off.
- When recharging refrigerant, check for leaks.