Harmonic Balancer - Crankshaft Pulley

Crankshaft Pulley





e. Tighten mounting bolts in numerical order as shown in the figure.
^ Install crankshaft pulley as follows:
a. Fix crankshaft using the ring gear stopper [SST: KV10117700 (J44716)].
b. Install crankshaft pulley, taking care not to damage front oil seal.
^ When press-fitting crankshaft pulley with plastic hammer, tap on its center portion (not circumference).
c. Tighten crankshaft pulley bolt.
44.1 Nm (4.5 kgf-cm, 33 ft. lbs.)





d. Put a paint mark on crankshaft pulley aligning with angle mark on crankshaft pulley bolt. Then, further retighten bolt by 60 to 65 degrees [Target: 60 degrees (equivalent to one graduation)].
^ Rotate crankshaft pulley in normal direction (clockwise when viewed from front) to confirm it turns smoothly.
^ For the following operations, perform steps in the reverse order of removal.