Component Inspection

Diagnostic Procedure

SYMPTOM 1:
^ Selector lever cannot be moved from "P" position with key in ON position and brake pedal applied.
^ Selector lever can be moved from "P" position with key in ON position and brake pedal released.
^ Selector lever can be moved from "P" position when key is removed from key cylinder.

SYMPTOM 2:
^ Ignition key cannot be removed when selector lever is set to "P" position.
^ Ignition key can be removed when selector lever is set to any position except "P" position.

1. CHECK KEY INTERLOCK CABLE
Check the key interlock cable for damage.
OK or NG
OK >> GO TO 2.
NG >> Repair or replace key interlock cable. Refer to "KEY INTERLOCK CABLE".

2. CHECK SELECTOR LEVER POSITION
Check the selector lever position for damage. Refer to "Checking of A/T Position"
OK or NG
OK >> GO TO 3.
NG >> Adjust control linkage. Refer to "Adjustment of A/T Position".

3. CHECK SHIFT LOCK SOLENOID AND PARK POSITION SWITCH
1. Connect A/T device harness connector.
2. Turn ignition switch ON.
3. Selector lever is set in P position.





4. Check operation sound.
OK or NG
OK >> INSPECTION END
NG >> GO TO 4.

4. CHECK POWER SOURCE
1. Turn ignition switch ON. (Do not start engine.)








2. Check the voltage between A/T device harness connector terminal 1 and ground. Refer to "Wiring Diagram - AT SHIFT".
OK or NG
OK >> GO TO 7.
NG >> GO TO 5.

5. CHECK STOP LAMP SWITCH
1. Turn ignition switch OFF.
2. Disconnect stop lamp switch harness connector.








3. Check continuity between stop lamp switch harness connector terminals.
Check stop lamp switch after adjusting brake pedal - refer to "BRAKE PEDAL".
OK or NG
OK >> GO TO 6.
NG >> Repair or replace damaged parts.

6. DETECT MALFUNCTIONING ITEM
^ Check the following items. If any items are damaged, repair or replace damaged parts.
^ Harness for short or open between ignition switch and stop lamp switch harness terminal 3.
^ Harness for short or open between stop lamp switch harness terminal 4 and A/T device harness terminal 1.
^ 10A fuse [No.1 2, located in the fuse block (J/B)].
^ Ignition switch, Refer to "POWER SUPPLY ROUTING CIRCUIT".
OK or NG
OK >> INSPECTION END
NG >> Repair or replace damaged parts.

7. CHECK GROUND CIRCUIT





1. Turn ignition switch OFF.
2. Disconnect A/T device harness connector.
3. Check continuity between A/T device harness connector terminal 2 and ground.
Continuity should exist.
OK or NG
OK >> Replace shift lock solenoid and park position switch assembly.
NG >> Repair open circuit in harness or connectors.