Removal and Installation

Removal and Installation
REMOVAL
1. Remove tunnel stay with power tool.
2. Remove exhaust front tube with power tool.
3. Remove front and rear propeller shaft.
4. Disconnect transfer assembly harness connector and separate harness from transfer assembly.
5. Remove air breather hose.
6. Support transfer assembly and transmission assembly with a jack.
7. Remove engine rear member with power tool.
8. Remove transfer mounting bolts and separate transfer from transmission.

CAUTION: Secure transfer assembly to a jack.

INSTALLATION








Note the following, and install in the reverse order of removal. When installing the transfer to the transmission, install the mounting bolts following the standard.
After the installation, check the fluid level and for fluid leakage.