Brake Fluid: Service and Repair

BRAKE FLUID
On-Board Inspection
LEVEL CHECK





^ Make sure the fluid level in reservoir tank is within the standard (between MAX and MIN lines).
^ Visually check around reservoir tank for fluid leaks.
^ If fluid level is excessively low, check brake system for leaks.
^ If brake warning lamp remains illuminated after parking lever is released, check brake system for fluid leakage.

Drain and Refill

CAUTION:
^ Refill with new brake fluid "DOT3".
^ Do not reuse drained brake fluid.
^ Do not let brake fluid splash on the painted surfaces of the body. This might damage the paint, so when splashing it, immediately wipe off the area and wash away with water.
^ Before servicing, disconnect actuator connector or battery negative cable.

1. Connect a vinyl tube to each bleed valve.





2. Depress brake pedal, loosen each bleed valve, and gradually remove brake fluid.





3. Make sure there is no foreign material in reservoir tank, and refill with new brake fluid.
4. Rest foot on brake pedal. Loosen bleed valve. Slowly depress pedal until it stops. Tighten bleed valve. Release brake pedal. Repeat this process a few times, then pause to add new brake fluid to master cylinder. Continue until new brake fluid flows out. Bleed Air. Refer to BR-10. "Bleeding Brake System".