Service Procedure A

SERVICE PROCEDURE A: Intelligent Key ID Registration Before starting this procedure, note the following:

^ Intelligent Key(s) to be registered must be inside the vehicle during the registration process.

^ Before starting the ID registration process for additional Intelligent Key: Remove Intelligent Keys from the vehicle which:

a. Have already been registered.

b. Belong to other vehicles.

^ Also remove from the vehicle any other transponders (such as Mobil Speed Pass etc.).

^ Use the NATS (purple) Program Card version AEN02C or later.

^ A maximum of four Intelligent Keys can be registered.

^ After ID registration always make sure that each Intelligent Key functions properly.

^ It is highly recommended that you read through the entire service procedure before doing it for the first time.

1. Insert the NATS (purple) Program Card into slot A of the CONSULT-II.

2. Connect CONSULT-II and CONSULT-II CAN converter and cable set to the vehicle's data link connector.





3. Insert a registered "emergency" or valet mechanical key into the ignition and turn the Ignition ON. Do Not start the engine.

NOTE:
The mechanical key used in step 3 above must be a NATS registered key. This would be the 'emergency key or the valet key.

4. Wait for the CONSULT-II system software to load then select the following:

[STAR] > [OTHER] > [OK] > [NATS I-KEY] > [WORK SUPPORT] > [REGIST I-KEY ID] > [START]

5. Push one of the remote control buttons (lock or unlock) on the Intelligent Key (see Figure 1) that is to be registered. This must be done with the Intelligent Key inside the vehicle.

6. When "REGISTRATION COMPLETED" is displayed on the CONSULT-II screen the ID registration is completed.

7. On the CONSULT-II screen select [CONTINUE] to register another Intelligent Key or [END] to exit the registration function.

8. Select [BACK] until you return to the SELECT SYSTEM screen.

NOTE:

^ After registering one or more new Intelligent Keys it is recommended that you check the function of all Intelligent Keys registered to the vehicle.

^ When the vehicle Intelligent Key ID memory cells are full: The oldest ID will be "erased" when a new ID is entered. It is possible to erase an existing Intelligent Key ID during the registration process.

9. Intelligent Key ID Registration Confirmation:

a. Using CONSULT-II: With the ignition ON select [NATS I-KEY] on the CONSULT-II screen.

b. Select [WORK SUPPORT]

c. Select [CONFIRM I-KEY ID]





d. Push any one of the remote control buttons on an Intelligent Key (see Figure 2). The MEMORY location number for that key will be indicated on the CONSULT-II screen.

e. Repeat step d for each registered Intelligent Key. Each registered key will have its own MEMORY location number.

NOTE:
If a MEMORY location number is indicated when pushing a button on an Intelligent Key it is registered. If "NOT REGIST" is displayed on the CONSULT-II screen that key is not registered.

10. Select [END] then [BACK] to return to the SELECT SYSTEM screen.

11. Turn the ignition OFF and return the emergency (mechanical) key to its Intelligent Key.

12. Turn the CONSULT-II unit OFF and disconnect it from the vehicle.