Disassembly and Assembly

Disassembly and Assembly






CAUTION: Sub fuel level sensor unit cannot be disassembled and should be replaced as a unit.

DISASSEMBLY
Remove fuel level sensor unit as follows.
1. Disconnect harness connector.




- Hold connector by fingers and pull it out, because there is no stopper release tab.




2. Using suitable tool, pull up tabs points as shown in the figure (two points) to release the lock.

CAUTION: Be careful not to damage it.




3. After fixing tabs are disengaged, slide fuel level sensor unit out in direction shown by the arrow.

CAUTION: Do not disassemble fuel filter and fuel pump assembly.

ASSEMBLY
1. Check for damage of fuel level sensor unit installation position on the side of fuel filter and fuel pump assembly.
2. Slide fuel level sensor unit until it aligns to installation groove, then insert it until stop.
- After inserting, apply force in reverse direction (removal direction) to ensure it cannot be pulled out.

3. Connect harness connector.
- Securely insert harness connector until it stops.