Self-Diag Result Mode

Operation Procedure
1. Perform CONSULT-II SETTING PROCEDURE. Refer to TF-22, CONSULT-II SETTING PROCEDURE. CONSULT-II Setting Procedure
2. Start engine and drive at 30 km/h (19 MPH) or more for approximately 1 minute.





3. Stop vehicle. With engine at idle, touch SELF-DIAG RESULTS. Display shows malfunction experienced since the last erasing operation.

NOTE:
^ The details for TIME are as follow:
^ 0: Error currently detected with AWD control unit.
^ Except for 0: Error detected in the past and memorized with AWD control unit. Detects frequency of driving after DTC occurs (frequency of turning ignition switch ON/OFF).