Over Fender

OVER FENDER




Removal and Installation

REMOVAL
1. Remove screws from front and/or rear over fender.

CAUTION: Never apply tack-paper adhesive remover to body panel surface finished with lacquer-based paints.

- Original over fenders are affixed to body panel with double-faced adhesive tape.

2. Heat over fender to between 30 ° and 40 °C (86 ° to 104 °F) with a heat gun.
3. Raise end of over fender and cut away tape, release plastic clips and remove over fender. Remove all traces of tape.

INSTALLATION
- On vehicles coated with Hard Clear Coat, use double-faced 3M adhesive tape Product No, 4210 or equivalent, after priming with 3M primer Product No. N200, C-100 or equivalent.
- The repair parts are also affixed with double-faced adhesive tape.
- To re-use existing over fender, clean all traces of double-faced tape from the over fender and apply new double-faced tape to the over fender.

1. Clean the panel surface with isopropyl alcohol or equivalent to degrease the surface.
2. Heat the panel and double-faced tape surface to 30 ° to 40 °C (86 ° to 104 °F).
3. Remove the backing sheet from the tape surface.
4. Align the plastic clips on the back side of the front and/or rear over fender to the mounting grommets.
5. Press ends by hand and use a roller to apply 5 kg-f (11 lbs-f) to press over fender surface to body panel.

CAUTION: To secure contact, do not wash vehicle for 24 hours after installation.

6. Secure front and/or rear over fender with screws.