Automatic Drive Positioner
Automatic Drive PositionerManual Operation
The driving position [seat position, steering wheel, pedal position (accelerator, brake) and door mirror position] can be adjusted with the power seat switch LH, pedal adjusting switch, door mirror remote control switch or ADP steering switch.
NOTE:
- The door mirrors can be manually operated with the ignition switch turned to ACC or ON.
- Adjustable pedals can only operate when A/T shift lever is in P position (except when ignition switch turned to OFF).
- If A/T device (detent switch) error is detected, manual adjustable pedal operation cannot be performed when ignition switch turns ON.
Automatic Operation
NOTE:
- Disconnecting the battery erases the stored memory.
- After connecting the battery, insert the key into the ignition cylinder and turn the front door switch LH ON (open) -> OFF (close) -> ON (open), the Entry/ Exiting function becomes possible.
- After Exiting operation is carried out, return operation can be operated.
NOTE: During automatic operation, if the ignition switch is turned ON -> START, the automatic operation is suspended. When the ignition switch returns to ON, it resumes.
System Description
- The system automatically moves the driver seat and steering wheel to facilitate entry/exit to/from the vehicle. The driver seat control unit can also store the optimum driving positions (driver seat, steering wheel, pedal position and door mirror position) for 2 people. One-touch operation allows changing between driving positions.
- The settings (ON/OFF) of the automatic sliding seat (Entry/Exiting operation) at entry/exit can be changed as desired, using the display unit in the center of the instrument panel. The set content is transmitted by CAN communication, from display control unit to driver seat control unit.
- Using CONSULT-II, the seat slide amount at entry/exit setting can be changed.
FAIL- SAFE MODE
When any manual and automatic operations are not performed, if any motor operations of seats or pedals are detected for T2 or more, status is judged "Output error".
CANCEL OF FAIL-SAFE MODE
The mode is cancelled when the selector lever is shifted to P position from any other position.