Crash Zone Sensor

CRASH ZONE SENSOR

Removal and Installation

REMOVAL

CAUTION:
- Before servicing the SRS, turn the ignition switch off, disconnect both battery cables and wait at least 3 minutes.




1. Remove front grille. Refer to "FRONT GRILLE".
2. Disconnect the crash zone sensor harness connector.
3. Remove crash zone sensor nuts.

CAUTION:
- Replace crash zone sensor if it has been dropped or sustained an impact.
- Do not disassemble crash zone sensor.

INSTALLATION
To install, reverse the removal procedure.
- After the work is complete, perform self-diagnosis to check that no malfunction is detected. Refer to SRS-21, "SRS Operation Check".