Clearing Trouble Codes

CONSULT-II Function (AIR LEVELIZER)
CONSULT-II can display each diagnostic item using the diagnostic test modes shown following.

CONSULT-II BASIC OPERATION PROCEDURE
1. Turn ignition switch OFF.





2. Connect CONSULT-II and CONSULT-II CONVERTER to the data link connector.

CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carries out CAN communication.

3. Turn ignition switch ON.





4. Touch "START (NISSAN BASED VHCL)".





5. Touch "AIR LEVELIZER" in the "SELECT SYSTEM" screen. If "AIR LEVELIZER" is not indicated, go to GI-38. "CONSULT-II Data Link Connector (DLC) Circuit".





6. Select the required operation from the "SELECT DIAG MODE" screen.

Self-Diagnosis
Description
If an error is detected in the system, perform self-diagnosis as follows:

Operation Procedure
1. Turn ignition switch OFF.
2. Connect CONSULT-II and CONSULT-II CONVERTER to the data link connector.

CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carries out CAN communication.

3. Turn ignition switch ON.
4. After stopping the vehicle, with the engine running, touch "START (NISSAN BASED VHCL)", "AIR LEVELIZER", "SELF-DIAG RESULTS" in order on the CONSULT-II screen.

CAUTION: If "START (NISSAN BASED VHCL)" is touched immediately after starting the engine or turning on the ignition switch, "AIR LEVELIZER" might not be displayed in the "SELECT SYSTEM" screen. In this case, repeat the operation from step 1.

5. The self-diagnostic results are displayed. (If necessary, the self-diagnostic results can be printed out by touching "COPY".)
^ When "NO DTC IS DETECTED" is displayed, check the CK SUSP indicator lamp.

6. Conduct the appropriate inspection from the display item list, and repair or replace the malfunctioning component.
7. Start and run the vehicle for approximately 1 minute.
8. Turn ignition switch OFF to prepare for erasing the memory.
9. Start the engine and touch "START (NISSAN BASED VHCL)", "AIR LEVELIZER", "SELF-DIAG RESULTS", "ERASE" in order on the CONSULT-II screen to erase the error memory. If "AIR LEVELIZER" is not indicated, go to GI-38. "CONSULT-II Data Link Connector (DLC) Circuit". Data Link Connector Schematic

CAUTION: If the error memory is not erased, re-conduct the operation from step 7.

10. For the final inspection, start and run the vehicle for approximately 1 minute and confirm that the CK SUSP indicator lamp is off.










Display Item List