Section 2

Section 2: Check all Systems in "SELF-DIAG RESULTS" and erase any DTC(s).

CAUTION:
It is essential that you check all Systems in "SELF-DIAG RESULTS" and erase any DTC(s) before performing the remaining sections of this procedure.

1. Remove the 8 MB orange card from CONSULT-II.





2. Install the 16 MB (red/white) Diagnostic Card into Slot A (top slot) of CONSULT-II (see Figure 12).

3. Press [START (Nissan BASED VHCL)].

4. In "SELF-DIAG RESULTS" check and erase any DTC(s) that are stored in the following vehicle Systems:

^ ENGINE

^ A/T

^ ABS

^ AIR BAG

^ ALL MODE AWD/4WD (if applicable)

^ DIFF LOCK (if applicable; 4WD Titan)

^ AIR LEVELIZER (if applicable)

5. Turn the ignition switch to the OFF position and then turn CONSULT-II OFF.

6. Remove the red/white Diagnostic Card and insert the 8 MB orange Reprogramming Card into CONSULT-II. The 8 MB reprogramming card should already have special ABS/VDC reprogramming data loaded into it (see Part 1).

7. Turn the ignition switch ON (do not start the engine).





^ CONSULT-II will turn ON automatically (see Figure 13).

^ Confirm that all electrical loads* (except for the ignition) are OFF.

* Headlights defroster A/C audio (radio) video and cellular telephone etc.





8. Roll down the driver's window part way exit the vehicle close the door and hang the CONSULT-II unit on the outside of the window (see Figure 14).

This step is necessary to make sure the CONSULT-II and DLC-II cable will not be disturbed during reprogramming.

CAUTION:
DO NOT connect the CONSULT-II AC power supply for Steps 1, 2, and 3 in Section 3 below.

9. Continue with Section 3 below.