Removal and Installation

FRONT FINAL DRIVE ASSEMBLY





Removal and Installation

REMOVAL
1. Remove front propeller shaft.

CAUTION: Be careful not to damage spline, sleeve yoke and front oil seal when removing propeller shaft.

2. Separate LH and RH drive shafts from front final drive.
3. Remove front cross member.
4. Disconnect the vent hose.





5. Support the front final drive with suitable jack and remove the front final drive bolts. Carefully remove front final drive.

INSTALLATION





1. Install front final drive assembly.
Front final drive bolts: 182.5 Nm (19 Kg-m, 135 ft. lbs.)
2. Connect the vent hose.
3. Install the front cross member.
4. Install LH and RH drive shaft.
5. Install front propeller shaft.