CONSULT-II Setting Procedure

FUNCTION





CONSULT-II can display each diagnostic item using the diagnostic test modes shown following.

CONSULT-II SETTING PROCEDURE

CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carry out CAN communication.





1. Turn ignition switch "OFF".
2. Connect CONSULT-II and CONSULT-II CONVERTER to data link connector on vehicle.
3. Turn ignition switch "ON".





4. Touch "START (NISSAN BASED VHCL)".





5. Touch "ALL MODE AWD/4WD". If "ALL MODE AWD/4WD" is not indicated, go to GI-38. "CONSULT-II Data Link Connector (DLC) Circuit". Data Link Connector Schematic
6. Perform each diagnostic test mode according to each service procedure.