Work Support
WORK SUPPORTWhen there is no problem with transfer and 4WD system, following symptom in "AUTO" mode may be claimed by a customer.
^ Vibration when accelerating on a low 11 road (snow-covered or icy road)
It is possible to deal with these symptoms by changing "CLUTCH FORCE RELEASE LIMIT VALUE".
However, be careful when changing the values because it may adversely affect driving performance.
NOTE: A slight shock is felt at a few hertz as if it were being pushed lightly from behind.
Operation Procedure
1. Perform "CONSULT-II SETTING PROCEDURE". Refer to TF-44, "CONSULT-II SETTING PROCEDURE"
2. Touch "WORK SUPPORT".
3. Select from "CLUTCH/F RLS LIM ADJ", screen of data monitor mode is displayed.
Clutch Force Release Limit Adjustment
1. Current CLUTCH FORCE RELEASE LIMIT value "0.3 kgm" appears under "CONDITION SETTING" on CONSULT-II display.
1.2 kg-m: Tight corner braking symptom is alleviated. However, vibration may occur when accelerating on a low 11 road (icy road, etc.).
0.3 kg-m: Initial set value.
0.2 kg-m: Do not set to this value because the tight corner braking symptom will get worse.
2. Touch "1.2" on the display.
3. Display changes to "NOW ADJUSTING" in a short time.
4. When clutch force release limit value is set to "1.2 kgm", current value "0.3 kgm" shown on display will be replaced by "1.2 kgm" and "ADJUSTMENT COMPLETE" will appear at the same time. Clutch force release limit value setting is now complete.