Powertrain Management: Technical Service Bulletins

• Recalls
  • Generals
    • Campaign - BCM Replacement/Sub-Harness Installation
      • Overview
      • Procedures A & B
      • Owner Letter
  • Safety
    • Recall PC069 - Engine Control Module Relay Replacement
      • Overview
      • Service Procedure
      • Owner Letter
    • Recall 10V517000: ECM Relay Replacement
    • Recall 10V074000: Fuel Sender Replacement
    • Recall R1011 - Fuel Level Sending Unit Replacement
      • Overview
      • Service Procedure
      • Owner Letter
• Customer Interest
  • Engine Controls - ECM Replacement Procedure
    • Overview
    • Service Procedure
  • A/C - Poor Cooling At Idle In Hot Temperatures
    • Overview
    • Service Procedure
      • Step A Confirm If the Vehicle Requires ECM Reprogramming
      • Step B Reprogram the ECM
      • Step C Replace the Engine Cooling Fan Coupling (Fan Clutch)
      • Step D Replace the Condenser & Fan Motor Assembly
      • Step E Install the Plastic Air Dam
  • Engine Controls - Idle Speed 25 RPM Too High
  • Engine Controls - MIL ON/DTC's P1273/P1283/P1274/P1284
  • Electrical - MIL ON/DTC's U1010 or U1000 Set
  • Engine Controls - Engine No Start/No Crank/DTC's Set
  • Instruments - Fuel Gauge Always Reads Full
  • Restraints - DTC B1177 or B1182 (Seat Belt Tensioner)
    • Overview
    • Service Procedures
      • Seat Belt Buckle Pre-Tensioner Harness Connector Replacement
      • Body Harness Connector Replacement
  • Fuel System - Low Power On Wide Open Acceleration
  • Instruments - Fuel Gauge Responds Slowly/Won't Read Full
• By Symptom
  • Abnormal wear/deterioration
    • Engine Controls - Engine No Start/No Crank/DTC's Set
  • Customer Interest
    • Engine Controls - ECM Replacement Procedure
      • Overview
      • Service Procedure
    • A/C - Poor Cooling At Idle In Hot Temperatures
      • Overview
      • Service Procedure
        • Step A Confirm If the Vehicle Requires ECM Reprogramming
        • Step B Reprogram the ECM
        • Step C Replace the Engine Cooling Fan Coupling (Fan Clutch)
        • Step D Replace the Condenser & Fan Motor Assembly
        • Step E Install the Plastic Air Dam
    • Engine Controls - Idle Speed 25 RPM Too High
    • Engine Controls - MIL ON/DTC's P1273/P1283/P1274/P1284
    • Electrical - MIL ON/DTC's U1010 or U1000 Set
    • Engine Controls - Engine No Start/No Crank/DTC's Set
    • Instruments - Fuel Gauge Always Reads Full
    • Restraints - DTC B1177 or B1182 (Seat Belt Tensioner)
      • Overview
      • Service Procedures
        • Seat Belt Buckle Pre-Tensioner Harness Connector Replacement
        • Body Harness Connector Replacement
    • Fuel System - Low Power On Wide Open Acceleration
    • Instruments - Fuel Gauge Responds Slowly/Won't Read Full
  • Driveability
    • Engine Controls - Engine No Start/No Crank/DTC's Set
    • Fuel System - Low Power On Wide Open Acceleration
  • Erratic Operation
    • Instruments - Fuel Gauge Responds Slowly/Won't Read Full
  • Erratic Shifting
    • Engine Controls - Engine No Start/No Crank/DTC's Set
  • False instrument warning light/gauges
    • Instruments - Fuel Gauge Always Reads Full
    • Instruments - Fuel Gauge Responds Slowly/Won't Read Full
  • Loose
    • Electrical - MIL ON/DTC's U1010 or U1000 Set
  • Noise
    • Engine - MIL ON/Multiple DTC's Set
  • Poor performance
    • A/C - Poor Cooling At Idle In Hot Temperatures
      • Overview
      • Service Procedure
        • Step A Confirm If the Vehicle Requires ECM Reprogramming
        • Step B Reprogram the ECM
        • Step C Replace the Engine Cooling Fan Coupling (Fan Clutch)
        • Step D Replace the Condenser & Fan Motor Assembly
        • Step E Install the Plastic Air Dam
  • Recalls
    • Recall PC069 - Engine Control Module Relay Replacement
      • Overview
      • Service Procedure
      • Owner Letter
    • Recall 10V517000: ECM Relay Replacement
    • Campaign - BCM Replacement/Sub-Harness Installation
      • Overview
      • Procedures A & B
      • Owner Letter
    • Recall 10V074000: Fuel Sender Replacement
    • Recall R1011 - Fuel Level Sending Unit Replacement
      • Overview
      • Service Procedure
      • Owner Letter
  • Slipping
    • Engine Controls - Engine No Start/No Crank/DTC's Set
  • Starting problems
    • Engine Controls - Engine No Start/No Crank/DTC's Set
• All Technical Service Bulletins
  • Computers/Controls - CAN Communication Diagnostic Flow Chart
  • Emissions - System Readiness Test (SRT) Drive Patterns
    • Overview
    • Service Procedure
    • System Readiness Test Drive Patterns
  • Computers/Controls - CONSULT III PLUS(R) Saved Data List
  • Engine Controls - ECM Replacement Procedure
    • Overview
    • Service Procedure
  • A/C - Poor Cooling At Idle In Hot Temperatures
    • Overview
    • Service Procedure
      • Step A Confirm If the Vehicle Requires ECM Reprogramming
      • Step B Reprogram the ECM
      • Step C Replace the Engine Cooling Fan Coupling (Fan Clutch)
      • Step D Replace the Condenser & Fan Motor Assembly
      • Step E Install the Plastic Air Dam
  • Computers/Controls - Reprogramming Utilizing CONSULT(R)
  • Vehicle - Certification Label/VIN Plate Replacement
  • Engine Controls - DTC P0335 Information
  • Recall PC069 - Engine Control Module Relay Replacement
    • Overview
    • Service Procedure
    • Owner Letter
  • Recall 10V517000: ECM Relay Replacement
  • Electrical - MIL ON/DTC P0128 Due To Remote Start Sys.
  • Engine Controls - ECM Programming Interruption Recovery
  • Computers/Control - CAN Code, Diagnostic Tips/Guidelines
  • A/T - 5 Speed A/T DTC Diagnostics
  • Engine Controls - CONSULT-III(R) ECM Programming
    • Overview
    • General Procedure
  • Electrical - Electronic Component Damage Prevention
  • Engine - MIL ON/Multiple DTC's Set
  • Engine Controls - ECM Reprogramming Information
    • Overview
    • Service Procedure
  • Engine Controls - Idle Speed 25 RPM Too High
  • Engine Controls - ECM Replacement Procedures
    • Overview
    • Service Procedure
  • Engine Controls - MIL ON/DTC's P1273/P1283/P1274/P1284
  • Electrical - MIL ON/DTC's U1010 or U1000 Set
  • Campaign - BCM Replacement/Sub-Harness Installation
    • Overview
    • Procedures A & B
    • Owner Letter
  • Engine Controls - Engine No Start/No Crank/DTC's Set
  • Instruments - Fuel Gauge Always Reads Full
  • Restraints - Service Tip for Pre-Tensioner DTC's
  • Restraints - DTC B1177 or B1182 (Seat Belt Tensioner)
    • Overview
    • Service Procedures
      • Seat Belt Buckle Pre-Tensioner Harness Connector Replacement
      • Body Harness Connector Replacement
  • Fuel System - Low Power On Wide Open Acceleration
  • Engine Controls - Seized O2 Sensor Removal Procedure
  • Emissions - EVAP Canister Vent Control Valve Replacement
  • Recall 10V074000: Fuel Sender Replacement
  • Instruments - Fuel Gauge Responds Slowly/Won't Read Full
  • Recall R1011 - Fuel Level Sending Unit Replacement
    • Overview
    • Service Procedure
    • Owner Letter
  • Body Controls - Configurable BCM Replacement Information