Closed Throttle Position and WOT Position Circuit

CLOSED THROTTLE POSITION AND WIDE OPEN THROTTLE POSITION CIRCUIT






CONSULT-II Reference Value

Diagnostic Procedure
1. CHECK CAN COMMUNICATION LINE
Perform the self-diagnosis. Refer to AT-85, "SELF-DIAGNOSTIC RESULT MODE".

Is a malfunction in the CAN communication indicated in the results?
YES >> Check CAN communication line. Refer to "DTC U1000 CAN COMMUNICATION LINE"Transmission Control Systems.
NO >> GO TO 2.

2. CHECK THROTTLE POSITION SIGNAL CIRCUIT
With CONSULT-II
1. Turn ignition switch "ON". (Do not start engine.)





2. Select "ECU INPUT SIGNALS" in "DATA MONITOR" mode for "A/T" with CONSULT-II.





3. Depress accelerator pedal and read out the value of "CLSD THL POS" and "W/O THL POS".

OK or NG
OK >> INSPECTION END
NG >> Check the following items. If NG, repair or replace damaged parts.
^ Perform the self-diagnosis for "ENGINE" with CONSULT-II.
^ Open circuit or short to ground or short to power in harness or connectors.
^ Pin terminals for damage or loose connection with harness connector.