Self-Diagnostic Function (With CONSULT-II)

Self-Diagnostic Function

WITH CONSULT-II
1. Go to operation check after asking the customer for symptom information. Refer to ACS-11, "ACTION TEST". Action Test
2. Stop vehicle, turn ignition switch OFF, then connect CONSULT-II and CONSULT-II CONVERTER to data link connector.
3. With engine started, touch "START (NISSAN BASED VHCL)", "ICC", "SELF-DIAG RESULTS" on CONSULT-II screen in this order.

CAUTION: If "ICC" cannot be shown after several attempts, the ICC unit may have had malfunction. Repair or replace it. Refer to GI-39, "CONSULT-II Data Link Connector (DLC) Circuit". Reading and Clearing Diagnostic Trouble Codes

4. Self-diagnostic result appears on screen. If "NO DTC..." is shown, check ICC warning lamp. If any malfunction is indicated, GO TO step 5.
5. According to "Diagnostic Trouble Code (DTC) Chart", perform appropriate check, and repair or replace malfunctioning part as necessary.
6. Turn ignition switch OFF.
7. Start the engine and touch "START (NISSAN BASED VHCL)", "ICC", "SELF-DIAG RESULTS", and "ERASE" on CONSULT-II display in turn to erase the memory.

CAUTION: If the memory does not erase, go to 5.

8. Perform ICC system running test (drive vehicle with ICC system ON), and make sure that ICC warning lamp does not illuminate.