Sunroof Motor Assembly

SUNROOF MOTOR ASSEMBLY




Removal
1. Remove headlining.
2. Remove motor mounting screw.
3. Disconnect harness connector from sunroof motor assembly, then remove sunroof motor assembly.

CAUTION:
- When removing the sunroof motor assembly, be sure that the sunroof is in the fully closed position.
- Do not run the removed sunroof motor assembly as a single unit.

Installation

Move the sunroof motor assembly laterally little by little so that the gear is completely engaged into the wire on the sunroof unit assembly and the mounting surface becomes parallel. Then secure the sunroof motor assembly with screws.









CAUTION:
- Before installing the sunroof motor assembly, be sure to place the link and wire assembly in the symmetrical and fully closed position.
- Confirm the body ground of the noise cover is connected.
- Initialization of it after installing the sunroof motor. Refer to "INITIALIZATION PROCEDURE".