Electronic Throttle Actuator: Service and Repair

Electric Throttle Control Actuator






REMOVAL

1. Remove electric throttle control actuator as follows:
a. Disconnect harness connector.





b. Loosen bolts in reverse order as shown in the figure.

CAUTION:
^ Handle carefully to avoid any shock to electric throttle control actuator.
^ Do not disassemble.

INSTALLATION

Electric Throttle Control Actuator
1. Install gasket with positioning no-protrusion surface upward or downward.





2. Tighten in numerical order as shown in the figure.
3. Perform the Throttle Valve Closed Position Learning when harness connector of electric throttle control actuator is disconnected. Refer to EC-84, Throttle Valve Closed Position Learning. Throttle Valve Closed Position Learning
4. Perform the Idle Air Volume Learning and Throttle Valve Closed Position Learning when electric throttle control actuator is replaced. Refer to EC-84, Idle Air Volume Learning. Programming and Relearning