Active Test

Active Test

CAUTION:
^ Do not perform active test while driving.
^ Make sure to completely bleed air from the brake system.
^ Active test can not be performed when EBD, ABS, TCS or VDC operation is malfunction.
^ ABS and brake warning lamps turn on during the active test.

OPERATION PROCEDURE
1. Perform CONSULT-II Starting Procedure. Refer to GI-38, CONSULT-II Start Procedure. Reading and Clearing Diagnostic Trouble Codes
2. Touch ACTIVE TESTS





3. The test item selection screen is displayed.
4. Touch necessary test item.
5. With the MAIN SIGNALS display shown in reverse, touch START.
6. The ACTIVE TEST screen will be displayed, so perform the following test.

TEST ITEM
Solenoid Valve

NOTE: The example shown is for the front right wheel. The procedure for the other wheels is the same as given below.





^ When performing an active test of the ABS function, select the main item for each test item. In addition, when performing an active test of the VDC/TCS function, select the item menu for each test item.
^ For the ABS solenoid valve, touch UP KEEP DOWN, and for the ABS solenoid valve (ACT), touch UP ACTUATOR UP ACTUATOR KEEP, and check to make sure that all solenoid valve (in, out) are operating as given in the table.





NOTE:
^ If active test is performed with brake pedal depressed, pedal stroke may change. This is normal.
^ TEST IS STOPPED is displayed approximately 10 seconds after operation starts.
^ After TEST IS STOPPED is displayed, touch BACK and perform the test from the Step 8.

ABS Motor





Touch ON and OFF on the screen. Make sure ABS motor relay operates as shown in table.





NOTE:
^ If active test is performed with brake pedal depressed, pedal stroke may change. This is normal.
^ TEST IS STOPPED is displayed approximately 10 seconds after operation starts.