Electronic Throttle Actuator: Service and Repair

ELECTRIC THROTTLE CONTROL ACTUATOR

Image Symbols:

REMOVAL

1. Remove electric throttle control actuator by loosening bolts diagonally

CAUTION:
^ Handle carefully to avoid any damage to the electric throttle control actuator.
^ Do not disassemble.

INSTALLATION

1. Tighten the electronic throttle control actuator bolts of the electric throttle control actuator equally and diagonally in several steps.
2. After installation perform procedure in EM-18, "INSPECTION AFTER INSTALLATION".
^ Perform procedures for "Throttle Valve Closed Position Learning" after finishing repairs. Refer to EC-90, "Throttle Valve Closed Position Learning". Throttle Valve Closed Position Learning
^ If electric throttle control actuator is replaced, perform procedures for "Idle Air Volume Learning" after finishing repairs. Refer to EC-91, "Idle Air Volume Learning". Programming and Relearning