Removal and Installation

G SENSOR

Removal and Installation
REMOVAL





1. Remove center console.
2. Disconnect G sensor harness connector.
3. Remove G sensor mounting bolts. Then remove G sensor from vehicle.

CAUTION:
^ Do not drop or strike G sensor, because it has little endurance to impact.
^ Do not use power tool etc., because G sensor is weak for the impact.

INSTALLATION
Note the following, and install in the reverse order of removal.

CAUTION:
^ Do not drop or strike G sensor, because it has little endurance to impact.
^ After performing above works, calibrate decel G sensor (AWD models). Refer to BRC-7, Calibration of Decel G Sensor (AWD Models). On-Vehicle Service