Reading and Clearing Diagnostic Trouble Codes
CONSULT-IICONSULT-II INSPECTION PROCEDURE
CAUTION: If CONSULT-II is used with no connection CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carry out CAN Communication.
1. Turn ignition switch OFF.
2. Insert IVIS (NATS) program card into CONSULT-II.
Program card : NATS (AEN04A-1)
3. Connect CONSULT-II and "CONSULT-II CONVERTER" to data link connector.
4. Turn ignition switch ON.
5. Touch "START".
6. Touch "OTHER".
7. Perform each diagnostic test mode according to each service procedure.
For further information, see the CONSULT-II Operation Manual, NATS-IVIS/NVIS.
CONSULT-II DIAGNOSTIC TEST MODE FUNCTION
NOTE: When any initialization is performed, all ID numbers previously registered will be erased and all ignition key or mechanical key must be registered again. The engine cannot be started with an unregistered key. The system will show "DIFFERENCE OF KEY" or "LOCK MODE" as a self-diagnostic result on the CONSULT-II screen.
HOW TO READ SELF-DIAGNOSTIC RESULTS
NATS Self - Diagnostic Result Item Chart:
NATS SELF-DIAGNOSTIC RESULT ITEM CHART