Crash Zone Sensor

CRASH ZONE SENSOR

Removal and Installation

REMOVAL

CAUTION:
- Before servicing SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes.
- Do not use air tools or electric tools for servicing.

1. Remove front grille.
2. Remove crash zone sensor connector.




3. Remove crash zone sensor fixing nuts.

CAUTION:
- Replace crash zone sensor if it has been dropped or sustained an impact.
- Do not disassemble crash zone sensor.
- Do not use old fixing nuts after removal; replace with new nuts.
- Replace the crash zone sensor of deployed SRS driver air bag and deployed SRS front passenger air bag.

INSTALLATION
Install in the reverse order of removal.

CAUTION:
- Be careful not to damage the crash zone sensor harness.
- After the work is completed, make sure no system malfunction is detected by air bag warning lamp.
- In case that malfunction is detected by the air bag warning lamp, reset by the self-diagnosis function and delete the memory by CONSULT-II.
- In case that malfunction is still detected after the above operation, perform self-diagnosis to repair malfunctions. Refer to SRS-20 "SRS Operation Check". SRS Operation Check (Procedure 1)