Replace the ICC Unit

Replace the ICC Unit

1. Turn the Ignition OFF.





2. Remove the front passenger kick plate.

^ Snap loose to remove.

^ Use a plastic trim tool as needed.





3. Under the glove box snap loose and remove the instrument lower cover.

^ Use a plastic trim tool as needed.





4. Remove the dash side finisher.

^ Remove plastic nut.

^ Snap finisher loose and remove.





5. Dismount the air bag connector shown in Figure D.

a. Snap open the door in the roof of the glove box.

b. Use a suitable tool to squeeze the clips and dismount the connector.





6. Remove the 2 screws from the lower part of the glove box.





7. Remove the 4 screws from the top of the glove box.





8. Pull / snap loose the glove box assembly and disconnect the glove box light connector.





9. Remove the 2 mounting nuts for the Engine Control Module (ECM).

NOTE:
It is not necessary to disconnect the ECM electrical connector.





10. The ECM can remain in this position while you replace the ICC unit.





11. Remove the ICC unit mounting nut and bolt.

NOTE:
The ICC unit is behind the harness junctions.





12. Carefully maneuver the ICC unit from behind the harness junctions.

13. Replace the ICC unit with a new one listed in the Parts Information of this bulletin.

^ Make the old ICC unit unusable by breaking the electrical connector.

14. Install the new unit and all other parts removed in reverse order.