How to Select Connecting Rod Bearing
HOW TO SELECT CONNECTING ROD BEARINGWhen New Connecting Rod and Crankshaft are Used
1. Apply the big end inside diameter grade stamped on the connecting rod side face to the row in the "Connecting Rod Bearing Selection Table".
2. Apply the pin diameter grade stamped on the crankshaft front side to the column in the "Connecting Rod Bearing Selection Table".
3. Read the symbol at the cross point of the selected row and column in the "Connecting Rod Bearing Selection Table".
4. Apply the symbol obtained to the "Connecting Rod Bearing Grade Table" to select.
When Crankshaft and Connecting Rod are Reused
1. Measure dimensions of the big end inside diameter of the connecting rod and diameter of the crankshaft pin individually.
2. Apply the measured dimension to the "Connecting Rod Bearing Selection Table".
3. The following steps are the same as in "When New Connecting Rod and Crankshaft are Used".
Connecting Rod Bearing Selection Table:
Connecting Rod Bearing Grade Table:
Undersize Bearings Usage Guide
^ When the specified oil clearance is not obtained with standard size connecting rod bearings, use undersize (US) bearings.
^ When using undersize bearing, measure the bearing inside diameter with the bearing installed, and grind the crankshaft pin so that the oil clearance satisfies the standard.
Bearing undersize table
Bearing undersize table:
CAUTION: In grinding the crankshaft pin to use undersize bearings, keep the fillet R (All crankshaft pins).
Fillet R: 1.5 - 1.7 mm (0.059 - 0.067 in)