Front

FRONT SEAT BELT RETRACTOR

Exploded View SB-4:

Removal

CAUTION:
- Before servicing SRS, turn the ignition switch off, disconnect both battery cables and wait at least 3 minutes.

1. Disconnect both battery cables. then wait at least 3 minutes.
2. Remove the center pillar upper/lower finishers. Refer to "BODY SIDE TRIM".
3. Remove the retractor anchor bolt, retractor bolt upper, then remove the retractor and belt assembly.
- On RH side, disconnect the seat belt tension sensor.

4. Disconnect the seat belt pre-tensioner electrical connector.






CAUTION:
- For removing pre-tensioner connector, insert a thin screwdriver (1) wrapped in tape (3) into the notch. Lift the locking tab to unlock (2), then remove the connector.
- Install the pre-tensioner connector with the locking tab raised, then push the locking tab into the connector to lock (4).

Installation
Installation is in the reverse order of removal.
- Install the seat belt retractor and belt assembly bolt upper first.
- Make sure the seat belt height adjuster is locked in the lowest position during installation.