Body - Power Window 'Auto Up' Inoperative
Classification: EL09-034Reference: ITB09-048
Date: September 25, 2009
2007-2009 QX56; POWER WINDOW "AUTO UP" INITIALIZATION
APPLIED VEHICLES:
2007 - 2009 QX56 (JA60)
IF YOU CONFIRM
A power window "Auto Up" will not work.
ACTION
Reset the limit switch.
1. Raise the door glass to the top position.
2. While pressing and holding the reset switch, lower the door glass to the bottom position.
3. Release the reset switch.
4. Verify that the reset switch returns to the original position.
If it does not, use a suitable tool to pull the switch.
5. Raise the door glass to the top position.
NOTES:
^ If the window is still not operating correctly, refer to ASIST and the Service Manual for further diagnosis and repair information.
^ The above initialization procedure must be performed if any of the following occur:
> Battery cable is disconnected.
> Power window switch connector is disconnected.
> Power window regulator is replaced.
> Power window motor is replaced.
> Window glass is removed.
> Window glass run rubber is replaced.
> Window is partly opened and/or closed many times without being fully closed.