Interior - Seat Back Board Removal/Installation
Classification BT08-022AReference ITB08-031A
Date July 21, 2009
SEAT BACK BOARD REMOVAL / INSTALLATION
This bulletin has been amended. Applied Vehicles has been updated. Discard all previous versions of this bulletin.
APPLIED VEHICLES: 2004 - 2009 QX56 (JA60)
SERVICE INFORMATION
This bulletin contains the Service Procedure for the removal and installation of the seat back board.
Refer to the Service Procedure in this bulletin for the removal and installation of the seat back board.
PARTS INFORMATION
SERVICE PROCEDURE
1 Move / adjust the right front passenger seat bottom and seat back to the full forward position.
2. Remove the right front hard seat back board as follows:
NOTE:
The seat back board is held on with:
^ 2 top tabs
^ 2 side tabs
^ 2 bottom clips (do not reuse, replace with new clips listed in the Parts Information table).
a. Lift up and pull bottom of seat back board away from seat back. See Figure 5.
b. Lift the middle part of the seat back board up and pull away from the seat back.
c. Slide the top part of the seat back board down, then pull away from the seat back.
7. Install seat back board:
a. Starting at the top place tabs underneath seat back frame and apply pressure until it is securely in place.
b. Install 2 new clips on the bottom part of the seat back board, then align bottom clips with holes in seat back frame until it clicks into place. See Parts Information table.
c. Apply pressure to both sides of the seat back board until the tabs click into place.
Disclaimer