Transfer Fluid Replacement

Exploded View TF-146 (Part 1):

Exploded View TF-146 (Part 2):

Exploded View TF-147 (Part 1):

Exploded View TF-147 (Part 2):

TRANSFER FLUID

Replacement
DRAINING
1. Stop the engine.





2. Remove the drain plug and gasket to drain the transfer fluid as shown.
3. Install the new gasket on the drain plug and install the drain plug in the transfer. Tighten the drain plug to specification.
Drain plug: Refer to Exploded View TF-146.

CAUTION: Do not reuse the gasket.

FILLING





1. Remove the filler plug and gasket.
2. Fill with new specified fluid until the fluid level reaches the specified limit near the filler plug hole as shown.
Fluid capacity and grade: Refer to MA-11, "Fluids and Lubricants". Maintenance

CAUTION: Carefully fill the transfer with fluid. Filling should take approximately three minutes.

3. Leave the vehicle for three minutes and then check the fluid level again as shown.
4. Install the new gasket on the filler plug and install the filler plug in the transfer. Tighten the filler plug to specification.
Filler plug: Refer to Exploded View TF-146.

CAUTION: Do not reuse the gasket.