Output Shaft Revolution Signal (TCM)

Output Shaft Revolution Signal (TCM)

DIAGNOSTIC PROCEDURE
1. CHECK DTC WITH TCM
Perform self-diagnosis with TCM. Refer to TF-49, "SELF-DIAGNOSTIC PROCEDURE (WITH CONSULT-II)". Self-Diagnostic Procedure (With Consult-II)
Is any malfunction detected by self-diagnosis?
YES >> Check the malfunctioning system.
NO >> GO TO 2.

2. CHECK TRANSFER CONTROL UNIT
Check transfer control unit input/output signal. Refer to TF-53, "TRANSFER CONTROL UNIT TERMINALS AND REFERENCE VALUE". Power Supply Circuit For Transfer Control Unit
OK or NG
OK >> GO TO 3.
NG >> Check transfer control unit pin terminals for damage or loose connection with harness connector. If any items are damaged, repair or replace damaged parts.

3. CHECK DTC
Perform the self-diagnosis, after driving a vehicle for a while.
OK or NG
OK >> Inspection End.
NG >> Perform self-diagnosis with TCM again. Refer to TF-49, "SELF-DIAGNOSTIC PROCEDURE (WITH CONSULT-II)". Self-Diagnostic Procedure (With Consult-II)