Part 2
Disassembly(continued)
36. Remove bracket from A/T fluid temperature sensor 2.
37. Remove O-ring from A/T assembly harness connector.
38. Disconnect TCM connectors.
CAUTION: Be careful not to damage connectors.
39. Remove A/T assembly harness connector from control valve with TCM using suitable tool.
40. Disconnect TCM connector and park/neutral position switch connector.
CAUTION: Be careful not to damage connectors.
41. Remove rear extension assembly (2WD models) or adapter case assembly (4WD models) according to the following procedures.
a. 2WD models
^ Self-sealing bolts (2)
i. Remove bolts for rear extension assembly and transmission case.
ii. Remove brackets (1).
iii. Tap rear extension assembly using suitable tool.
iv. Remove rear extension assembly with needle bearing from transmission case.
b. 4WD models
^ Self-sealing bolts (2)
i. Remove bolts for adapter case assembly and transmission case.
ii. Remove brackets (1).
iii. Tap adapter case assembly using suitable tool.
iv. Remove adapter case assembly with needle bearing from transmission case.
v. Remove gasket from transmission case.
42. Remove bearing race from output shaft.
43. Remove output shaft from transmission case by rotating left/right.
44. Remove parking gear from output shaft.
45. Remove seal rings from output shaft.
46. Remove needle bearing from transmission case.
47. Remove revolution sensor from transmission case.
CAUTION:
^ Do not subject it to impact by dropping or hitting it.
^ Be careful not to damage harness with the edge of case.
^ Do not allow metal filings or foreign material to get on the sensor front edge magnetic area.
^ Do not place in an area affected by magnetism.
48. Remove reverse brake snap ring using 2 flat-bladed screwdrivers.
NOTE: Press out snap ring from the transmission case oil pan side gap using a flat-bladed screwdriver, and remove it using another screwdriver.
49. Remove reverse brake retaining plate from transmission case.
50. Remove N-spring from transmission case.
51. Remove reverse brake drive plates, driven plates and dish plate from transmission case.
52. Remove snap ring from transmission case while compressing return spring, using Tool.
Tool number: KV31102400 (J-34285 and J-34285-87)
53. Remove spring retainer and return spring from transmission case.
54. Remove seal rings from drum support.
55. Remove needle bearing from drum support edge surface.
56. Remove reverse brake piston from transmission case with compressed air.
CAUTION: Care should be taken not to abruptly blow air. It makes pistons incline, as the result, it becomes hard to disassemble the pistons.
57. Remove D-rings from reverse brake piston.
58. Knock out retaining pin using suitable tool.
59. Remove manual shaft retaining pin using suitable tool.
60. Remove manual plate (with parking rod) from manual shaft.
61. Remove parking rod from manual plate.
62. Remove manual shaft from transmission case.
63. Remove manual shaft oil seals using suitable tool.
CAUTION: Be careful not to scratch transmission case.
64. Remove detent spring and spacer from transmission case.
65. Remove snap ring from transmission case using suitable tool.
66. Remove servo assembly (with return spring) from transmission case.
67. Remove return spring from servo assembly.
68. Remove O-rings from servo assembly.
69. Remove parking actuator support from rear extension (2WD models) or adapter case (4WD models).
70. Remove parking pawl (with return spring) and pawl shaft from rear extension (2WD models) or adapter case (4WD models).
71. Remove return spring (1) from parking pawl (2).
72. Remove needle bearing from rear extension (2WD models) or adapter case (4WD models).
73. Remove rear oil seal from rear extension (2WD models) or adapter case (4WD models) using suitable tool.
CAUTION: Be careful not to scratch rear extension (2WD models) or adapter case (4WD models).