Rear Seat

REAR SEAT

Exploded View

SE-98 Exploded View (Part 1):

SE-98 Exploded View (Part 2):

Removal and Installation

REMOVAL

CAUTION: When removing and installing, use shop cloths to protect parts from damage.

1. Remove the seat cushion.





- Pull the lock lever (1) at the front bottom of the seat cushion forward (1 for each side), and pull the seat cushion upward to release the wire (2) from the seat cushion hook. Then pull the seat cushion forward the remove
- Remove the seat cushion from vehicle.
2. Remove the seatback.
- Remove the luggage floor finisher front LH and RH.
- Disconnect the rear seat harness connectors.
- With power return seat model
LH seatback





Disconnect the rear seat harness connectors (A).

RH seatback





Disconnect the rear seat harness connector (A).
- Without power return seat model

LH seatback





Disconnect the rear seat harness connectors (A).

RH seatback





Disconnect the rear seat harness connector (A).





- Push the seatback lock pin (A).
- Remove the seatback mounting nuts (B), (C) and bolt (D).
- Remove the center seat belt anchor bolt. (RH seatback only) Refer to SB-10, "SEAT BELT RETRACTOR : Exploded View".
- Remove the seatback from vehicle.

INSTALLATION





1. Install the rear seatback mounting nuts (1), (2), (3).
2. Lock the seatback striker (4).
3. Install the rear seatback mounting bolts (5).
4. Pull the rear seatback lock pin (6).

CAUTION:
- When removing and installing, use shop cloths to protect parts from damage.
- When removing and installing, 2 workers are required so as to prevent it from dropping.