Programming and Relearning

LASER BEAM AIMING ADJUSTMENT

LASER BEAM AIMING ADJUSTMENT: Description

OUTLINE OF LASER BEAM AIMING ADJUSTMENT
Adjust the laser beam aiming every time the ICC sensor integrated unit is removed or installed.
1. Set up the ICC target board [SST: KV99110100 (J-45718)].
2. Adjust the sensor following the procedure on CONSULT-III. (Turn manually the screw for up-down position adjustment. ICC sensor integrated unit automatically adjust the right-left position.)

CAUTIONARY POINTS FOR LASER BEAM AIMING

CAUTION:
- Adjust laser beam aiming at a horizontal place as far as 12 m (39 ft) forward the vehicle can be seen.
- Adjust laser beam aiming 5 seconds after starting engine.
- Never view ICC sensor integrated unit body window directly during laser beam aiming adjustment.
- Follow the CONSULT-III when adjusting the laser beam aiming (laser beam aiming adjustment cannot be operated without CONSULT-III).
- Never ride on vehicle during laser beam aiming adjustment.
- Idle and turn headlamps OFF during laser beam aiming adjustment.

LASER BEAM AIMING ADJUSTMENT: Special Repair Requirement (Preparation)

Step 1:

Step 1 (Continued):

LASER BEAM AIMING ADJUSTMENT: Special Repair Requirement (Setting The ICC Target Board)

Step 1:

Step 1 (Continued)-3:

Step 3 (Continued)-5:

LASER BEAM AIMING ADJUSTMENT: Special Repair Requirement (Laser Beam Aiming Adjustment)

Step 1-3:

Step 3 (Continued):