Transmitter ID Registration Procedure
ID REGISTRATION PROCEDURE: DescriptionThis procedure must be done after replacing or rotating wheels, replacing transmitter or BCM.
ID REGISTRATION PROCEDURE: Special Repair Requirement
1. ID REGISTRATION PREPARATION
1. Touch "WORK SUPPORT" on "SELECT DIAG MODE" screen, and select "ID REGIST".
Is the transmitter activation tool used for ID registration?
YES >> GO TO 2.
NO >> GO TO 3.
2. ID REGISTRATION (WITH TRANSMITTER ACTIVATION TOOL)
1. With the transmitter activation tool (J-45295) pushed against the front-left transmitter position of the air valve, press and hold the button for 5 seconds.
2. Register the IDs in order from FR LH, FR RH, RR RH, to RR LH. When ID registration of each wheel has been completed, turn signal lamp blinks.
3. After completing all ID registrations, press "END" to complete the procedure.
NOTE: Be sure to register the IDs in order from FR LH, FR RH, RR RH, to RR LH, or the self-diagnostic results display will not function properly.
Can ID registration of all transmitters be completed?
YES >> ID registration END
NO >> Inspect the tire pressure monitoring system. Refer to WT-18, "Diagnosis Procedure". C1708
3. ID REGISTRATION (WITHOUT TRANSMITTER ACTIVATION TOOL)
1. Adjust the tire pressure to the values shown in the table below for ID registration, and drive the vehicle at 40 km/h (25 MPH) or more for several minutes.
NOTE: If ID registration is unable, buzzer beeps.
2. After completing all ID registrations, press "END" to complete procedure.
3. Inflate all tires to proper pressure. Refer to WT-104, "Tire Air Pressure". [1][2]Specifications
Can ID registration of all transmitters be completed?
YES >> ID registration END
NO >> Inspect the tire pressure monitoring system. Refer to WT-18, "Diagnosis Procedure". C1708