Seat Synchronization Function
SEAT SYNCHRONIZATION FUNCTIONSEAT SYNCHRONIZATION FUNCTION : System Diagram
SEAT SYNCHRONIZATION FUNCTION : System Description
OUTLINE
The steering column position and door mirror position is adjusted to the position automatically according to the direction and distance of seat movement when performing the manual operation of sliding, reclining or lifting (rear). This function saves adjusting the mirror and steering column when adjusting the seat.
NOTE:
- This function is set to OFF before delivery (initial setting).
- This function can be stopped by turning both or either of the entry/exit assist function (seat) and the entry/ exit assist function (steering) OFF.
OPERATION PROCEDURE
1. Turn ignition switch ON.
2. Adjust seat position [sliding, reclining, lifting (rear)].
3. The steering and outside mirror is adjusted automatically.
NOTE:
- The seat synchronization function will not operate if seat adjusting value is more than limit value.
- The seat synchronization function will not operate if the steering column or door mirror moves to the operating end while this function is operating. Perform memory function or drive the vehicle at vehicle speed of 7 km/h or more once to activate this function again.
- If the seat position is uncomfortable after the adjustment, seat position can be adjusted easily by memory operation.
OPERATION CONDITION
Satisfy all of the following items. The seat synchronization function is not performed if these items are not satisfied.
DETAIL FLOW
SEAT SYNCHRONIZATION FUNCTION : Component Description
CONTROL UNITS
INPUT PARTS
Switches
Sensors
OUTPUT PARTS
