Main Bearing Cap

Main Bearing Cap





Install main bearing cap bolts in numerical order as shown in the figure as follows:
Inspect the outer diameter of main bearing cap bolt. Refer to EM-138, "Inspection After Disassembly". Inspection After Disassembly
Apply new engine oil to threads and seat surfaces of main bearing cap bolts.
Tighten main bearing cap bolts in several different steps.
Torque 35.3 Nm (3.6 kg-m, 26 ft-lb)





Turn all main bearing cap bolts 90 degrees clockwise (Angle tightening).

CAUTION:
Use the angle wrench [SST: KV10112100 (BT8653-A)] to check tightening angle. Do not make judgment by visual inspection.

After installing main bearing cap bolts, make sure that crankshaft can be rotated smoothly by hand.
Check the crankshaft end play. Refer to EM-138, "Inspection After Disassembly". Inspection After Disassembly

MAIN BEARING CAP BOLT OUTER DIAMETER





Measure the outer diameters ("d1", "d2") at two positions as shown in the figure.
If reduction appears in "A" range, regard it as "d2".
Limit ("d1" - "d2") 0.11 mm (0.0043 in)
If it exceeds the limit (large difference in dimensions), replace main bearing cap bolt with new one.