Headlamp Bulb: Service and Repair
Bulb ReplacementHEADLAMP HIGH/LOW BEAM
1. Turn lighting switch OFF.
2. Disconnect the battery cable from the negative terminal or remove power fuse.
3. Remove air cleaner case (when replacing LH bulb).
4. Remove radiator reservoir tank (when replacing RH bulb).
5. Turn plastic cap counterclockwise and unlock it.
6. Turn bulb socket counterclockwise and unlock it.
7. Unlock retaining spring and remove bulb from headlamp.
8. Installation is the reverse order of removal.
NOTE: After installation, perform aiming adjustment. Refer to LT-27, "Aiming Adjustment". Adjustments
Headlamp high/low beam (Xenon): 12 V - 35 W (D2S)
DAYTIME/PARKING LAMP
1. Turn lighting switch OFF.
2. Remove air cleaner case (when replacing LH bulb of VK45).
3. Turn bulb socket counterclockwise and unlock it.
4. Remove bulb from its socket.
5. Installation is the reverse order of removal.
Daytime/Parking lamp: 12 V - 21/5 W
FRONT TURN SIGNAL LAMP
1. Turn lighting switch OFF.
2. Turn bulb socket counterclockwise with suitable tool and unlock it.
3. Remove bulb from its socket.
4. Installation is the reverse order of removal.
Front turn signal lamp: 12 V - 21 W (amber)
FRONT SIDE MARKER LAMP
1. Turn lighting switch OFF.
2. Turn bulb socket counterclockwise and unlock it.
3. Remove bulb from its socket.
4. Installation is the reverse order of removal.
Front side marker lamp: 12 V - 3.8 W
CAUTION: After installing bulb, be sure to install plastic cap and bulb socket securely to insure watertightness.